My Fluval 405 has arrived and I will be setting-it up on saturday.
I have noticed however that I won't be able to close the lid on my aquarium as this filter will have 2 hosing comming down.
What can I do ? I am not sure if the fishes would jump, if I leave one part of the lid off ?
I am thinking maybe to cut a hole on the lid ??
But on the other hand I am affraid if I am going to damage the VERY expensive aquarium...
How do you do your's ??
Thank you for your help.
You will have to perform some 'cabinet surgery' to your tank lid. You firstly need to figure out where you are going to position the inlet and outlet pipes for the filter, then cut out a small area from the lid so that the pipes just fit through. Any bigger and you may risk fish jumping out, so you need to ensure quite a snug fit. A tool such as a junior hacksaw may be the best implement to use, and just be patient and cut slowly and gently so as not to cause cracks in the lid.
The Juwel tanks usually need their lids modifying when adding extra equipment, so you are not alone. Other makes of tanks sometimes come with gaps as the back of the hood to allow for pipes, leads etc, and others come with 'knock-out' panels that can be taken out if necessary (and save you from having to cut them).
Good luck, and let us know if you get stuck when you are installing it on Saturday.
East of the Sun, West of the Moon.
Who is online
Users browsing this forum: Google [Bot] and 16 guests