As long as the intake is not too low sand does not get up into the filter.
If you have fish that dig, then you might keep the intake high enough that they won't kick up the sand that high, and put a coarse sponge over the intake.
I only had one tank where the fish rearranged the substrate that much, it had Botia kubotai, but I also had the intake quite low, so it may not have been entirely the fault of the fish. The substrate was coarser than sand, and all it did was to clog up the sponge over the intake. Other species of fish dig a lot more than these guys. Yoyos and Clown Loaches seem to dig the most, IME, but none of them can match certain Cichlids for the amount of digging they can do.
Happy fish keeping!
As far as the sand goes, I decided to take the motor apart and check the impeller and the sand amount was negligible. This was done a couple weeks ago and the first time I did a big cleaning.
As I’d said earlier I keep the intake tube quite high so sand is barely an issue. I also didn’t use aquarium sand but, rather, pool sand which I was told is less fine and less likely to kick up as much.
Who is online
Users browsing this forum: No registered users and 3 guests